SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 666 (CELLULAR COMMUNICATION SYSTEM)REPAIR INSTRUCTIONSNAVIGATION ANTENNA REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the surface of the rear shelf in the GPS antenna mounting location, using an isopropyl alcohol pad and a clean lint-free cloth.

    Important:  Do not touch the adhesive backing.

  2. Remove the protective backing from the adhesive backing of the GPS antenna.
  3. Install the GPS antenna to the rear shelf surface.

    Press the GPS antenna into place until fully seated for approximately 30 seconds.

    Fig 1: Installing Global Positioning System Antenna To Rear Shelf
    G01503455Courtesy of GENERAL MOTORS CORP.
  4. Connect the GPS antenna cable connector.
  5. Install the rear shelf trim panel. Refer to TRIM PANEL REPLACEMENT - REAR WINDOW SHELF in Interior Trim.
    Fig 2: Connecting Global Positioning System Antenna Cable Connector
    G01503456Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.