Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the BPMV bracket (4) to the wheel house.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the 3 BPMV bracket nuts (1) (2) and (3) to the studs on the BPMV bracket (4).

    Tighten 

    Tighten the 3 BPMV bracket nuts to 10 N.m (7 lb ft).

  3. Install the BPMV and EBCM as an assembly to the BPMV bracket. Refer to Brake Pressure Modulator Valve (Bpmv) Replacement  .
  4. Turn the ignition switch to the RUN position.
  5. Perform the Diagnostic System Check - ABS  .
    Fig 1: Installing BPMV Bracket & Nuts
    G01490674Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.