Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 624 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD LATCH REPLACEMENT - LEFTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install the cable end into the catch on the latch.
Install the cable sheath grommet into the slotted hole in the latch.

Fig 1: Installing Cable End Into Catch On Latch
Courtesy of GENERAL MOTORS CORP.
Install the hood latch and attaching bolts.
Align the latch within the marked area.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Tighten the hood latch bolts.
Tighten

Tighten the hood latch bolts to 10 N.m (89 lb in).
Install the cable sheath to the push-in retainer.

Fig 2: Hood Latch
Courtesy of GENERAL MOTORS CORP.
Install the air inlet grille. Refer to AIR INLET GRILLE PANEL REPLACEMENT .

Fig 3: Air Inlet Grille
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.