SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 614 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSANTENNA CABLE STRAP REPLACEMENT (CONVERTIBLE)REMOVAL PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screws retaining the left inner tail lamp.
  2. Remove the left inner tail lamp.
  3. Remove the screws retaining both of the right tail lamps.
  4. Remove both of the right tail lamps.
  5. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  6. Remove the right rear tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  7. Remove the right rear wheelhouse filler panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Rear End.
  8. Disconnect the antenna electrical connector from the rear body wiring harness.

    Important:  Use care not to twist and damage the ground straps when removing the retaining nut.

  9. Remove the nut retaining the antenna dual cable strap (1), and the antenna short braided ground strap (2) to the rear fascia retaining stud, then reposition the straps.

    Important  : Take note of the positioning of the antenna dual cable strap retaining clips to the rear compartment flange, prior to removal.

  10. Beginning from the right side, release the antenna dual cable strap retaining clips from the rear compartment flange.
  11. Remove the antenna strap from the vehicle.
    Fig 1: Removing Nut Retaining Antenna Dual Cable Strap & Antenna Short Braided Ground Strap
    G01453640Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.