Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 54 (ENGINE CONTROL SYSTEM SELF-DIAGNOSTICS - 3.4L)DIAGNOSTIC TESTSDTC P0325: KNOCK SENSOR MODULE CIRCUITDIAGNOSTIC PROCEDURES
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Diagnostic Procedures
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Diagnostic Procedures
WARNING: This page is about a different car, the 2002 Pontiac Grand Am, 2002 Oldsmobile Alero, 2002 Chevrolet Monte Carlo, and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Perform diagnostic system check - engine controls. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM. After performing diagnostic system check - engine controls, go to next step.
- Observe the Freeze Frame/Failure Records data for this DTC. Turn ignition off for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC or within the observed parameters of the Freeze Frame/Failure Records. See CONDITIONS FOR RUNNING DTC . Does the DTC fail this ignition? If yes, go to next step. If no, see INTERMITTENT CONDITIONS under SELF-DIAGNOSTIC SYSTEM.
- Replace PCM. Perform PCM relearn procedure. See POWERTRAIN CONTROL MODULE under PROGRAMMING. After replacing PCM, go to next step.
- Use the scan tool in order to clear the DTCs. Turn ignition off for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running in the DTC. See CONDITIONS FOR RUNNING DTC . Did the DTC Run and Pass? If yes, go to next step. If no, go to step 2.
- Using scan tool, observe stored information and Capture Info. Does scan tool displays any undiagnosed DTCs? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.