Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Hub & Bearing Assembly - Rear
    GM230412Courtesy of GENERAL MOTORS CORP.
  1. Install the hub and bearing assembly (1) to the vehicle. Refer to Wheel Bearing/Hub Replacement - Rear (Front Wheel Drive/Drum) or Wheel Bearing/Hub Replacement - Rear (Disc and AWD) in Rear Suspension.
  2. Fig 2: View Of Wheel Speed Sensor Components
    GM561883Courtesy of GENERAL MOTORS CORP.
  3. Install the rear wheel speed sensor electrical connector.
  4. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
  6. Turn the ignition switch to the RUN position with the engine off.
  7. Perform the Diagnostic System Check - ABSΒ .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.