SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 507 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)REPAIR INSTRUCTIONSTRIM PANEL REPLACEMENT - SIDE FRONT DOOR (AZTEK)REMOVAL PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the door.
  2. Remove the power window switch assembly. Refer to Power Window Switch Replacement - Left Front (Aztek)  or Power Window Switch Replacement - Left Front (Rendezvous)  or Power Window Switch Replacement - Right Front (Aztek)  or Power Window Switch Replacement - Right Front (Rendezvous) .
  3. Remove the screws from the front door trim panel
    Fig 1: View Of Front Door Trim Panel Screws (Aztek)
    GM621726Courtesy of GENERAL MOTORS CORP.
  4. Remove the front door trim panel using the J 38778  .
  5. Remove the power mirror switch. Refer to Power Mirror Switch Replacement (Aztek)  or Power Mirror Switch Replacement (Rendezvous)  if equipped.
  6. Reposition the electrical harness connectors.
    Fig 2: View Of Inner Door (Aztek)
    GM621722Courtesy of GENERAL MOTORS CORP.
  7. Remove the front door trim panel from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.