Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Vanity Mirror Lamp Lens Bulb
    GM64702Courtesy of GENERAL MOTORS CORP.
  1. Install the bulb into the socket.
  2. Fig 2: Identifying Vanity Mirror Lamp Lens
    GM64700Courtesy of GENERAL MOTORS CORP.
  3. Position the vanity mirror lamp lens to the sunshade.

    Align the lens tabs into the housing slots and insert the upper edge of the lens first.

  4. Fig 3: Installing/Removing Vanity Mirror Lamp Lens
    GM66090Courtesy of GENERAL MOTORS CORP.
  5. Insert a small flat-bladed tool at the lower edge of the vanity mirror lamp lens then press up to fully install the lens.
  6. Close the lamp cover door and raise the sunshade.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.