SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 506 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSSTOP LAMP SWITCH REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Stop Lamp Switch & Cruise Control Switch
    GM180295Courtesy of GENERAL MOTORS CORP.
  1. Install the stop lamp switch (1) into the slotted grooves until switch is fully depressed against the brake pedal (2), then turn the switch clockwise approximately 1/4 turn, the switch should now be installed and adjusted.
  2. Connect the electrical connectors.
  3. Install the left side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages and Console.
  4. If necessary, adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.