Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Important:Β  The keys on the recliner handle must properly align to the keyways on the recliner handle shaft.

  1. Position the seat back recliner handle to the seat back recliner handle shaft.
  2. Install the seat back recliner handle to the seat back recliner handle shaft pressing on until properly seated.
    Fig 1: Installing Seat Back Recliner Handle To Seat Back Recliner Handle Shaft
    G01518081Courtesy of GENERAL MOTORS CORP.
  3. Install the screw to the seat back recliner handle.

    TightenΒ 

    Tighten the seat back recliner screw to 2 N.m (18 lb in).

    Fig 2: Installing Screw To Seat Back Recliner Handle
    G01518082Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.