SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 42 (AUTOMATIC TRANSAXLE SERVICING)REMOVAL & INSTALLATIONCONTROL VALVE BODYINSTALLATION
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Control Valve Body: Installation

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ball check valves (372) into the case cover. See Figure . Use the (J-36850) Transjel(tm) to retain the ball check valves in their proper locations. Install the gasket and the spacer plate (370). See Figure .
  2. Install the ball check valves (372 and 373) into the valve body. See Figure . Use the Transjel(tm) to retain the ball check valves in their proper locations.
    3. NOTE: Do not use impact type tools on the valve body or on the oil pump.
  3. Install the gasket (371) and the valve body (300). See Figure . Install the valve body bolts (374-381 and 384). See Figure .
  4. Tighten the valve body bolts as follows:
    • M6 X 1.0 X 20 - 70 INCH lbs. (8 N.m).
    • M6 X 1.0 X 30 - 106 INCH lbs. (12 N.m).
    • M6 X 1.0 X 45 - 106 INCH lbs. (12 N.m).
    • M6 X 1.0 X 55 - 97 INCH lbs. (11 N.m).
    • M6 X 1.0 X 60 - 106 INCH lbs. (12 N.m).
    • M6 X 1.0 X 65 - 106 INCH lbs. (12 N.m).
    • M6 X 1.0 X 85 - 97 INCH lbs. (11 N.m).
    • M6 X 1.0 X 90 - 97 INCH lbs. (11 N.m).
    • M8 X 1.0 X 90 - 18 ft. lbs. (25 N.m).
  5. DO NOT use impact type tools on the valve body or on the oil pump. Install the oil pump. See OIL PUMP  . Install the case side cover. See CASE SIDE COVER  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.