Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 397 (THEFT DETERRENT SYSTEM)REPAIR INSTRUCTIONSTHEFT DETERRENT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Position the theft deterrent module to the opening in the IP retainer.

Fig 1: Installing Theft Deterrent Control Module
Courtesy of GENERAL MOTORS CORP.
Push the theft deterrent module (3) downward until the retainer clip (2) engages, securing the module to the IP retainer.
Connect the theft deterrent module electrical connector (1).
Install the Instrument Panel Trim Plate Bezel.
Refer to TRIM PLATE BEZEL REPLACEMENT -- IP CLUSTER .
Perform the Programing Theft Deterrent System Components procedure. Refer to Programming Theft Deterrent System Components .

Fig 2: Connecting Theft Deterrent Control Module
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.