Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 391 (BODY REAR END)
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Section 391 (Body Rear End)
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Section 391 (Body Rear End)
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Fuel Filler Door Release Switch Replacement
- Rear Compartment Lid Switch Replacement
- Compartment Sill Plate Replacement - Rear
- Compartment Trim Panel Replacement - Rear
- Compartment Lid Trim Replacement - Rear
- Compartment Lid Applique Replacement - Rear
- Fuel Filler Door Replacement
- Fuel Filler Door Release Actuator Replacement
- Compartment Lid Adjustment-Rear
- Compartment Lid Replacement - Rear
- Hinge Replacement - Rear Compartment Lid
- Torque Rod Replacement-Rear Compartment Lid
- Torque Rod Adjustment - Rear Compartment Lid
- Lock Cylinder Replacement - Rear Compartment Lid (L47 Engine, 4.0L V8/Aluminum Lid)
- Lock Cylinder Replacement - Rear Compartment Lid (LX5 Engine, 3.5L V6/Steel Lid)
- Handle Replacement - Rear Compartment Lid Interior Release
- Latch Replacement - Rear Compartment Lid (w/o Inside Release Handle)
- Lock Striker Replacement - Rear Compartment Lid
- Pressure Relief Valve Replacement
- Weatherstrip Replacement - Rear Compartment Opening
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.