Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 387 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)REPAIR INSTRUCTIONSROLLER TRACK REPLACEMENT - SLIDING DOOR CENTERREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, and 2002 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.

Remove the passenger side body side trim panel. Refer to TRIM PANEL REPLACEMENT - RIGHT BODY SIDE .
Remove the sliding side door lower trim panel. Refer to Trim Panel Replacement - Sliding Door Lower .
Remove the sliding side door center track stop nuts and washers from the vehicle.
Remove the sliding side door center track stop from the vehicle.
Remove the sliding side door center track cap nut and plate from the vehicle.
Remove the sliding side door center track cap from the vehicle.
Remove the sliding side door center roller bracket. Refer to Roller Bracket Replacement - Center .
Remove the nuts and the washers that retain the sliding side door center track to the body.
Remove the sliding side door center track from the vehicle.

Fig 1: Removing Sliding Side Door Center Track

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.