Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 386 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSMEMORY SEAT SWITCH REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora and 2001 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

Remove the inside handle bezel from the door trim pad. Refer to HANDLE BEZEL REPLACEMENT -- INSIDE in Doors.
Remove the front door switch plate. Refer to FRONT DOOR SWITCH REPLACEMENT in Doors.

Fig 1: Removing Front Door Switch Plate

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector for the memory seat switch through the power door switch opening in the door trim panel.
Remove the memory seat switch from the inside handle bezel by releasing the tabs with a small flat bladed tool.
Gently remove the electrical wiring for the memory seat switch from behind the door trim panel.

Fig 2: Removing Memory Seat Switch
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.