Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 380 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT REPLACEMENT - SPLIT BENCHINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Installation Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Position the front seat into the vehicle.
Tip the front seat forward to engage the front hook attachments.
Connect the front seat electrical connectors.
NOTE: Refer to FASTENER NOTICE .
Install the front seat adjuster to floor pan bolts. Tighten the bolts to 42 N.m (31 lb ft).

Fig 1: Identifying Front Seat Adjuster-To-Floor Pan Bolts

Courtesy of GENERAL MOTORS CORP.

Reposition the front seat to the full back position.
Install the front seat track adjuster covers. Refer to Seat Adjuster Track Cover Replacement - Front .
Install the seat belt anchor plate nut. Tighten the nut to 42 N.m (31 lb ft).

Fig 2: Identifying Seat Belt Anchor Plate Nut

Courtesy of GENERAL MOTORS CORP.

Install the head restraint. Refer to Head Restraint Replacement - Front Seat .
Enable the SIR system if seat is equipped with air bag. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.