Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 360 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSWINDSHIELD REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Installation Procedure
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary WindowsΒ .
- Install the air inlet grille in reverse of removal procedure.
- Install the windshield wipers arms and blades. Refer to WIPER ARMS .
- Install the windshield garnish molding in reverse of removal procedure.
- Install the rearview mirror. Refer to Rearview Mirror ReplacementΒ .
- Connect the rain sensor connector, if equipped.
- Connect the diversity antenna, if equipped.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.