Removal Procedure

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor console and reposition the console slightly rearward. Refer to CONSOLE REPLACEMENT - FRONT FLOOR (D06) or CONSOLE REPLACEMENT - FRONT FLOOR (D55) in Instrument Panel, Gages and Console.
  2. Disconnect the electrical connector (2) from the console compartment lamp switch.
  3. Fig 1: Identifying Console Lamp Switch & Connector
    G01754889Courtesy of GENERAL MOTORS CORP.
  4. Open the console compartment door.
  5. Release the retaining tab on the underside of the switch, while sliding the switch rearward.
  6. Lift to remove the switch from the top of the console compartment.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.