SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 335 (WHEEL ALIGNMENT SPECIFICATIONS & ADJUSTMENT PROCEDURES)REPAIR INSTRUCTIONSREAR TOE ADJUSTMENT
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F

Rear Toe Adjustment

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Rear Toe Adjustment
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen the hex nuts at the rear wheel spindle rod (rear).
    Fig 1: Rear Wheel Spindle Rod Hex Nut
    G01720501Courtesy of GENERAL MOTORS CORP.
  2. Turn the adjusting nut to change the toe angle.
  3. Adjust the toe to the proper setting. Refer to Figure.
    Fig 2: Adjusting The Toe To The Proper Setting
    G01720502Courtesy of GENERAL MOTORS CORP.
  4. Tighten the hex nuts on the rear wheel spindle rod (rear).

    Tighten: 

    Tighten the rear wheel spindle rod ends hex nuts to 50 N.m (37 ft lbs) 

    Fig 3: Rear Wheel Spindle Rod Hex Nut
    G01720503Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.