Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 327 (REAR SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTRUT ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Installation Procedure
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.
- Install the strut into place.
- Install the strut to knuckle bolts. Tighten the strut to knuckle bolts and nuts to 120 N.m (89 ft lbs).
- Install the bolt (2) to the brake hose bracket (3) and the strut assembly. Tighten the bolt to 27 N.m (20 ft lbs).
- Connect the stabilizer shaft link to the strut.
- Install the tire and wheel.
- Install strut to body mount nuts (1). Tighten the strut to body mount nuts to 45 N.m (33 ft lbs).
- Lower the vehicle.
- Adjust the rear wheel alignment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.