Radiator Inlet Hose: Installation

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install hose end marked "eng" to engine port, orient "H" on hose to 12 o'clock.
  2. Install clamp at 12 o'clock.
    Fig 1: Installing Hose And Clamp To Engine Port
    G01041316Courtesy of GENERAL MOTORS CORP.
  3. Install hose to radiator with "H" oriented to 12 o'clock.
  4. Install clamp at 6 o'clock.
  5. Fill cooling system.
    Fig 2: Installing Hose And Clamp To Radiator
    G01041317Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.