Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 252 (ENGINE CONTROLS - BASIC DIAGNOSTIC PROCEDURES)FUEL SYSTEMSFUEL SYSTEM DIAGNOSISDIAGNOSTIC PROCEDURE
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Diagnostic Procedure
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Diagnostic Procedure
WARNING: This page is about a different car, the 2003 Cadillac Seville and 2003 Cadillac DeVille. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Fuel Pipe Shut-Off Adapters (J 37287) are required for this procedure.
- If diagnostic system check has already been performed, go to next step. If diagnostic system check has not been performed, go to go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 4.6L DEVILLE & SEVILLE article.
- Turn ignition ON, with engine OFF. Using scan tool, command fuel pump ON. Does fuel pump operate? If yes, go to next step. If no, go to FUEL PUMP ELECTRICAL CIRCUIT DIAGNOSIS .
NOTE:
Inspect fuel system for damage or external leaks before proceeding with this diagnostic.
NOTE:
Ensure there is adequate fuel in fuel tank before proceeding with this diagnostic
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.