Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Air Cleaner Assembly: Installation
Install the air cleaner tub by pressing downward on the tub until the grommets are seated on the mounting studs. See Fig 1 . Insert the air cleaner element into the air cleaner tub. Install the air cleaner cover which contains the MAF and IAT sensors. Tighten the clamp to specification. See TORQUE SPECIFICATIONS . Install the air cleaner cover. Fasten the air cleaner cover retainer clips. Connect the MAF and IAT sensor harness connectors. Connect the negative battery cable. Tighten battery cable to specification.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.