Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 199 (ENGINE CONTROLS SELF-DIAGNOSTICS)DIAGNOSTIC TESTSDTC P0506: IDLE CONTROL SYSTEM - LOW RPMCONDITIONS FOR RUNNING DTC
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Conditions For Running DTC
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0125, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0300, P0401, P0403, P0404, P0405, or P502 not set.
- Engine run time is more than 2 minutes.
- Engine Coolant Temperature (ECT) sensor is more than 158°F (70°C).
- Intake Air Temperature (IAT) sensor is more than 0°F (-18°C).
- Barometric (BARO) pressure sensor is more than 70 kPa.
- Ignition 1 Signal parameter is 9-18 volts.
- Throttle Position (TP) sensor angle is less than 1.5 percent.
- Vehicle Speed Sensor (VSS) is less than 3 MPH.
- Conditions are met for more than 8 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.