Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 190 (SERVICING - A/T (VT25-E))REMOVAL & INSTALLATIONCONTROL CABLEINSTALLATION
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Control Cable: Installation
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Installation
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Route control cable through cable bracket. See Figure .
- Secure cable to bracket with control cable retainer clip. An audible snap will be heard when properly installed. See Figure .
- With transaxle range switch lever located in Neutral, snap cable end fitting onto ball stud of lever. An audible snap will be heard when properly installed.
- Position the vehicle on a hoist and raise the vehicle.
- Route the cable along the steering gear assembly into the clip and up into the dash panel. See Figure .
- Lower the vehicle.
- Secure control cable grommet by pressing cable into pass-through hole in dash panel. See Figure .
- Make sure control assembly is in Neutral position.
- Connect control cable to control assembly. Secure with control cable retainer clip. See Figure .
- Install control cable onto control assembly lever.
- Adjust control cable assembly. See CONTROL CABLE under ADJUSTMENTS.
- Install console. See CONSOLE .
- Position battery tray bracket and tighten screws to specification. See Figure and TORQUE SPECIFICATIONS .
- Install battery cooling box. See BATTERY COOLING BOX .
- Insert battery and tighten battery hold-down screw to specification. Connect positive battery cable to battery and tighten to specification. Connect negative battery cable to battery and tighten to specification. Install battery cooling box cover and tighten screws to specification. See TORQUE SPECIFICATIONS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.