Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 6.5 FREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 155 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 2.2L)DIAGNOSTIC TESTSDTC P0130: HO2S CIRCUIT (SENSOR 1)CONDITIONS FOR RUNNING DTC
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 F
Conditions For Running DTC
2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Conditions For Running DTC
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0105, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0128, P0171, P0172, P0201, P0202, P0203, P0204, P0300-P0304, P0336, P0440, P0442, P0446, P0452, P0453, P0506, P0507, P0601, P0602, P0604, P0606, P1120, P1220, P1221, P1271, P1275, P1280, P1441, P1512, P1514, P1515, P1516, P1621, P1635, P1639, P1680, or P1681 not set.
- Engine Run Time parameter is more than 200 seconds.
- Engine Speed parameter is 1200-3400 RPM.
- TP Angle parameter is 10-40 percent.
- ECT Sensor parameter is greater than 158°F (70°C).
- APP Angle parameter is greater than 1.2 percent.
- Conditions are met for 2 seconds.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.