Removal & Installation

2001 Chevrolet Chevy Express G3500, Van Passenger Extended, 6.5 FSECTION Removal & Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure.

  1. Remove rear shelf trim from inside rear storage compartment. See TRUNK TRIM PANELSΒ .
  2. Disconnect harness connectors.
  3. Push on retainers (1) and remove Remote Control Door Lock Receiver (RCDLR) (2) from bracket. See Fig 1.
  4. To install, reverse removal procedure. Program RCDLR for transmitters. See REMOTE KEYLESS ENTRY TRANSMITTERΒ  under PROGRAMMING.
Fig 1: Removing Remote Control Door Lock Receiver
G00193415Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.