Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Inspection/Maintenance Complete System Set PROCEURE: Description
This procedure satisfies enable criteria necessary to execute all monitor diagnostics, and complete trips for those particular diagnostics. When all diagnostic tests have been completed, I/M System Status indicators are set to YES. Perform this test when more than one or all I/M System Status indicators are set to NO.
Ensure vehicle meets the following conditions before performing procedure:
- Engine Coolant Temperature (ECT) is less than 133°F (56°C).
- Intake Air Temperature (IAT) is greater than 20°F (7°C).
- Transmission fluid temperature is 68-266°F (20-130°C).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.