Circuit Description

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Circuit Description
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic test functions on the assumption that an ABS event and sudden decrease in a non-drive, wheel speed must be caused by a brake application. Non-drive wheel speed and stoplamp switch status are supplied to the PCM through serial data from the Electronic Brake Control Module (EBCM). If there is a 4.02 km/h (2.5 mph) or greater decrease of non-drive wheel speed in 0.4 seconds and a transition of the TCC or extended travel contacts of the TCC brake switch without a transition of the stop lamp brake switch, DTC P1574 is set.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.