Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the trim panel on the seat.

    Refer to Fastener Notice in Cautions and Notices.

  2. Fig 1: Front Seat Trim Panel
    GM378528Courtesy of GENERAL MOTORS COMPANY
  3. Install the screws retaining the trim panel to the seat.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  4. Install the remaining screws retaining the seat back release handle and the seat recliner handle to the seat.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.