Scan Tool Data List

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Scan Tool Data List
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Scan Tool Data List

Scan Tool Parameter Data List Units Displayed Typical Data Value
Ignition ON/Engine OFF/Vehicle in PARK/Headlamps in AUTO
Julian Date Module Information 1 Numeric Varies
Manufacture Enable Counter Module Information 1 0-255 0
Module Part Number Module Information 1 Numeric Varies
Software Design Suffix Module Information 1 Two Letters Varies
Software Part Number Module Information 1 Numeric Varies
Lighting Calibration Number Module Information 2 Numeric Varies
Lighting Suffix Module Information 2 Two Letters Varies
Reminder Calibration Number Module Information 2 Numeric Varies
Reminder Suffix Module Information 2 Two Letters Varies
RAP Calibration Number Module Information 2 Numeric Varies
RAP Suffix Module Information 2 Two Letters Varies
Ambient Light Data DARK/LIGHT LIGHT (DRL ON) DARK (AHL ON)
Ambient Light Sensor Data Volts 4.7 Volts Maximum Light to 1.0 Volt Maximum Dark
Battery Voltage Data Volts Varies
Courtesy Lamp Timer Data Seconds 0 Seconds
Dimming Potentiometer Data Volts Varies
High Beam Input Data Volts 12.2 - Low Beams 0.8 - High Beams
Inadvertent Power Timer Data Seconds 2400 Seconds
RAP Timer Data Seconds 1198 Seconds
Cargo Lamp Switch Input 1 ON/OFF OFF
Driver Door Jamb Sw. Input 1 ACTIVE/INACTIVE ACTIVE (door open)
Ignition 1 Input 1 ACTIVE/INACTIVE ACTIVE
Ignition 3 Input 1 ACTIVE/INACTIVE ACTIVE
Ignition Power Mode Input 1 OFF/RUN/CRANK/ UNKNOWN RUN
Last RFA Cmd. Since Wake-Up Input 1 None/Lock/Unlock/Panic/Manual Resynch/Fob Program/Diag Acknowledge/Diag Request Unlock
Park Brake Switch Input 1 SET/RELEASED RELEASED (park brake not set)
Pass Door Unlock Input Input 1 ACTIVE/INACTIVE INACTIVE
RFA Message Since Wake-Up Input 1 NONE/PANIC/Active Unlock Fob# /Active Lock/Prog Mode Cancel/Prog Successful/Prog Mode Ack/Manual Resync Actv Unlock Fob#
RAP Relay Feedback Input 1 ON/OFF ON
Cargo Lamp Switch Input 2 ON/OFF OFF
Courtesy Lamp Relay Input 2 ON/OFF OFF
Dim Pot Input Input 2 ACTIVE/INACTIVE ACTIVE
Dome Lamp Switch Input 2 ON/OFF OFF
Dome Override Switch Input 2 ON/OFF OFF
Flash to Pass Switch Input 2 ON/OFF OFF
Front Fog Lamp Switch Input 2 ON/OFF OFF
Headlamp Relay Feedback Input 2 ON/OFF OFF (in LIGHT state)
High Beam Switch Input 2 ON/OFF OFF
Left Turn Signal Input 2 ON/OFF OFF
Park Lamps Input 2 ON/OFF ON
Right Turn Signal Input 2 ON/OFF OFF
Chime Outputs None/Headlamp/Turn Signal/Key In Ignition/Seatbelt/Park Brake None
Courtesy Lamp Relay Outputs ON/OFF OFF
DRL Relay Outputs ON/OFF ON (in LIGHT state)
Dimming Outputs ACTIVE/INACTIVE INACTIVE (park lamps OFF)
Front Fog Lamp Relay Outputs ON/OFF OFF
Headlamp Power Relay Outputs ON/OFF OFF (in LIGHT state)
Inadvertent Power Relay Outputs ON/OFF ON
Interior Lighting Mode Outputs None/Interior/Illuminated Entry/Exit Lighting/Remote Illuminated Interior
Park Lamp Relay Outputs ON/OFF OFF (in LIGHT state)
Passenger Door Unlock Relay Outputs ON/OFF OFF
Rear Fog Lamp Relay Outputs ON/OFF OFF
RAP Relay Outputs ON/OFF ON
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.