SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 916 (INSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLE)REPAIR INSTRUCTIONSCENTER CONSOLE END PANEL REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power outlets to the end panel, if equipped.
  2. Install the console floor lamp, if equipped. Refer to Console Lamp Replacement in Lighting Systems.
  3. Install the rear seat audio controls, if equipped. Refer to Rear Seat Audio Control Replacement in Entertainment.
  4. Install the rear seat heater switch, if equipped. Refer to Rear Seat Heater Switch Replacement in Seats.
  5. Connect all electrical connectors.
  6. Install the end panel to the console.
    7. Fig 1: Center Console End Panel Screws
    GM754997Courtesy of GENERAL MOTORS COMPANY
  7. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the 2 top retaining screws (1).

    Tighten 

    Tighten the screws to 1.6 N.m (14 lb in).

    8. Fig 2: Center Console End Panel Screws
    GM754995Courtesy of GENERAL MOTORS COMPANY
  8. Install the 4 retaining screws (1).

    Tighten 

    Tighten the screws to 1.6 N.m (14 lb in).

  9. Install the rear cupholder to the end panel. Refer to Front Floor Console Cup Holder Replacement .
  10. Install the storage bin. Refer to Front Floor Console Compartment Replacement (Non-Luxury) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.