SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 9 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC U1305: CLASS 2 DATA LINK SHORTED TO GROUND/POWERDESCRIPTION
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

DTC U1305: Class 2 Data Link Shorted To Ground/Power: Description

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Description
WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2001 Chevrolet Monte Carlo, and 2001 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Modules connected to class 2 serial data circuit monitor for serial data communications during normal vehicle operation. Operating information and commands are exchanged among modules. In addition to this, state of health messages are transmitted by each module on class 2 serial data circuit about once every 2 seconds. When a module detects no messages on class 2 serial data circuit for approximately 3 seconds, with no low or high voltage detected, U1305 is set. Setting of all other class 2 serial communication DTCs is inhibited.

DTC U1305 is set when, no valid class 2 messages are detected on class 2 serial data circuit. Problem is met for approximately 3 seconds.

When DTC U1305 is set, module inhibits setting of all other class 2 DTCs. Module uses default values for all parameters received on class 2 serial data circuit.

Current DTC U1305 will clear and become a history DTC when a valid class 2 message is detected on class 2 serial data circuit or at end of current ignition cycle. History DTC U1305 will clear after 100 ignition on/off cycles with no repeated malfunction.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.