Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wiper Motor Components
    GM632378Courtesy of GENERAL MOTORS COMPANY
  1. Remove the wiper arm. Refer to Rear Window Wiper Arm ReplacementΒ .
  2. Remove the nut and spacer from the wiper motor shaft.
  3. Remove the interior trim panel. Refer to Liftgate Trim Panel Replacement in Body Rear End.
  4. Disconnect the wiper motor electrical connector.
  5. Remove the two screws.
  6. Remove the wiper motor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.