Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 GMC C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Water Pump Outlet Pipe
    GM699336Courtesy of GENERAL MOTORS COMPANY
  1. Install a new O-ring seal on the water pump outlet pipe.
  2. Lightly lubricate the O-ring seal with engine oil.
  3. Install the water pump outlet pipe in the engine oil cooler assembly.
  4. Install a new water pump outlet pipe to water pump gasket.
  5. Install the oil filter adapter and oil cooler assembly. Refer to Oil Filter Adapter and Oil Cooler Assembly Replacement .
  6. Fig 2: View Of Wheelhouse Panel & Push-In Retainers
    GM401885Courtesy of GENERAL MOTORS COMPANY
  7. Install the left front fender wheelhouse inner panel (1).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.