SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 878 (ENGINE CONTROLS - 8.1L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSFUEL LEVEL SENSOR REPLACEMENT (REAR TANK)INSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, 2001 GMC C3500 HD, and 2001 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Fuel Sender Assembly
    GM645600Courtesy of GENERAL MOTORS COMPANY
  1. Install the fuel level sensor (4).
  2. Install the sensor retaining clip .
  3. Connect the electrical connector to the fuel level sensor.
  4. Connect the retaining clip to the fuel level sensor electrical connector.
  5. Connect the fuel pump electrical connector .
  6. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.