Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 878 (ENGINE CONTROLS - 8.1L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSEXHAUST GAS RECIRCULATION VALVE BRACKET REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, 2001 GMC C3500 HD, and 2001 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.

Install a new gasket (3) on the intake manifold.

Fig 1: View Of EGR Valve Adapter Bracket, Gasket, And Retaining Nuts

Courtesy of GENERAL MOTORS COMPANY

Refer to FASTENER NOTICE in Cautions and Notices.
Install the EGR valve adapter bracket (2) and two nuts (1).

Tighten

Tighten the nuts to 22 N.m (16 lb ft).
Install the EGR Pipe. Refer to Exhaust Gas Recirculation Pipe Replacement .
Install the EGR Valve. Refer to Exhaust Gas Recirculation Valve Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.