Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 877 (ENGINE CONTROLS - 4.8L, 5.3L, AND 6.0L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSCRANKSHAFT POSITION SENSOR REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2001 GMC Yukon XL, 2001 GMC Yukon, 2001 GMC Sierra, 2001 GMC Cab & Chassis Sierra, and 2001 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Install the CKP sensor.
Refer to FASTENER NOTICE in Cautions and Notices.

Fig 1: View Of CKP Sensor & Bolt

Courtesy of GENERAL MOTORS COMPANY

Install the CKP sensor retaining fastener.
Tighten

Tighten the fastener to 25 N.m (18 lb ft).

Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector

Courtesy of GENERAL MOTORS COMPANY

Connect the CKP sensor electrical connector.

Fig 3: View Of Starter

Courtesy of GENERAL MOTORS COMPANY

Install the starter. Refer to Starter Replacement (4.8L, 5.3L, and 6.0L Engines) in Engine Electrical.
Lower the vehicle.
Connect the negative battery cable.
Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.