Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 876 (ENGINE CONTROLS - 4.3L - REPAIR INSTRUCTIONS)REPAIR INSTRUCTIONSTHROTTLE POSITION SENSOR REPLACEMENTINSTALLATION PROCEDURE
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M
Installation Procedure
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2001 GMC Sierra and 2001 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the TP sensor on the throttle shaft.
- Align the TP sensor flange holes with the throttle body attaching screw holes.
- Refer to FASTENER NOTICE
in Cautions and Notices.
Install the TP sensor attaching screws.
Tighten
Tighten the TP sensor attaching screws to 2 N.m (18 lb in).
- Connect the TP sensor harness connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.