Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 859 (THEFT DETERRENT)REPAIR INSTRUCTIONSTHEFT DETERRENT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page is about a different car, the 2001 GMC C3500 HD and 2001 Chevrolet C3500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Slide In Rear Tabs Of Module

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector.
Slide in the rear tabs of the module.
Push up in order to engage the module.
Install the ashtray. Refer to Ashtray Replacement in Instrument Panel, Gages and Console.
Install the IP auxiliary storage compartment, if equipped. Refer to Instrument Panel Compartment Replacement in Instrument Panel, Gages and Console.
Install the knee bolster. Refer to Knee Bolster Replacement (Non-Luxury) or Knee Bolster Replacement (Luxury) in Instrument Panel, Gages and Console.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.