Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front DoorΒ .
  2. Remove the front door water deflector. Refer to Water Deflector Replacement - Front DoorΒ .
  3. Remove the screw from the front door window run channel.
  4. Pull down to unclip the top edge of the window run channel.
  5. Remove the front door window run channel from the front door.
    Fig 1: Window Run Channel
    G01617140Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.