Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 766 (STEERING WHEEL AND STEERING COLUMN)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M
Fastener Tightening Specifications
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Shift Lever Screw | 20 N.m | 15 lb ft |
| Ignition Switch Assembly Screws | 1.5 N.m | 13 lb in |
| Linear Shift Assembly to Steering Column Mounting Screws | 10 N.m | 89 lb in |
| Intermediate Shaft to the Steering Gear Pinch Bolt | 48 N.m | 35 lb ft |
| Intermediate Shaft Seal Bolts | 3 N.m | 27 lb in |
| Intermediate Shaft to the Steering Column Pinch Bolt | 48 N.m | 35 lb ft |
| Steering Column Trim Cover Screws Lower | 3.5 N.m | 31 lb in |
| Steering Column Mounting Bolts (Tighten in Sequence) | 24 N.m | 18 lb ft |
| Steering Column Support Assembly TORX® Head Screws | 17 N.m | 13 lb ft |
| Steering Column Trim Cover Screws Upper | 1.5 N.m | 13 lb in |
| Steering Wheel Nut | 45 N.m | 33 lb ft |
| Turn Signal Multifunction Switch Screws Side | 7 N.m | 62 lb in |
| Turn Signal Multifunction Switch Screws Top | 3 N.m | 30 lb in |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.