Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 755 (AUTOMATIC TRANSMISSION, 4L60-E/4L65-E (TROUBLESHOOTING))TROUBLESHOOTINGAUTOMATIC TRANSMISSION OIL COOLER FLUSHING AND FLOW TEST (J 35944-A)CLEAN-UP
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M
Automatic Transmission Oil Cooler Flushing and Flow Test (J 35944-A): Clean-up
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Clean-up
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the water supply hose from the J 35944-A and bleed any remaining air pressure from the flusher tank.
- Remove the fill cap from the J 35944-A and return any unused flushing solution to its container. Rinse the J 35944-A with water. Do not store the J 35944-A with flushing solution in it.
- After every third use, clean the J 35944-A as described in the instructions included with the tool.
- Dispose of any waste water/solution and transmission fluid in accordance with local regulations.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.