SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 73 (ENGINE CONTROLS - REMOVAL, OVERHAUL & INSTALLATION)IGNITION SYSTEMSCRANKSHAFT POSITION SENSORREMOVAL (2.2L)
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Removal (2.2L)

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal (2.2L)
WARNING: This page is about a different car, the 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Position (CKP) sensor is located in cylinder block, behind the starter motor. See Figure . Turn OFF the ignition. Record preset radio stations. Disconnect negative battery cable. Disconnect wiring at starter solenoid. Raise and support vehicle. Remove the two starter solenoid harness connector attachment nuts.
  2. Remove lower starter assembly-to-engine block bolt. Remove upper starter assembly-to-engine block bolt. Move starter right to clear engine block, then left to remove starter from flywheel housing. Disconnect CKP sensor harness connector. Remove CKP sensor attachment bolt and remove CKP sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.