Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 705 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - REARINSTALLATION PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Fog Lamp Bezel At Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Position the rear fog lamp assembly to the rear fascia.
Install the bezel to the lamp.
Insert the bezel into the slot on the lamp, then pivot the bezel onto the stud.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear fog lamp bezel retaining nut.
Tighten: Tighten the rear fog lamp bezel retaining nut to 2 N.m (18 lb in).

Fig 2: Rear Fog Lamp Socket At Rear Fog Lamp Assembly

Courtesy of GENERAL MOTORS CORP.

Install the socket to the lamp.
Install the tail/turn signal lamp. Refer to Tail/Turn Signal Lamp Replacement (Europe, Japan) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.