Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 704 (STEERING WHEEL AND STEERING COLUMN)COMPONENT LOCATORSTEERING COLUMN DISASSEMBLED VIEW (MANUAL)
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M
Steering Column Disassembled View (Manual)
2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Steering Column Disassembled View (Manual)
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | Upper Trim Cover |
| 2 | Lower Trim Cover |
| 3 | TORX® Head Screws |
| 4 | Windshield Wiper and Washer Switch Assembly |
| 5 | Flanged Prevailing Torque Nut |
| 6 | Retaining Ring |
| 7 | SIR Coil |
| 8 | Wave Washer |
| 9 | Bearing Retainer |
| 10 | Cam Orientation Plate |
| 11 | Turn Signal Cancel Cam Assembly |
| 12 | Upper Bearing Spring |
| 13 | Upper Bearing Inner Race Seat |
| 14 | Inner Race |
| 15 | Pan Head Tapping Screws |
| 16 | Steering Wheel Theft Deterrent Lock |
| 17 | Pan Head Tapping Screw |
| 18 | Wiper/Washer Switch Bracket |
| 19 | Steering Column Tilt Head Housing |
| 20 | Wire Harness Spacer |
| 21 | Wire Harness Straps |
| 22 | Pan Head Tapping Screws |
| 23 | Turn Signal and Multifunction Switch Assembly |
| 24 | Race and Upper Shaft Assembly |
| 25 | Joint Preload Spring |
| 26 | Centering Sphere |
| 27 | Lower Steering Shaft Assembly |
| 28 | TORX® Head Screws |
| 29 | TORX® Head Screws |
| 30 | Tilt Bumpers |
| 31 | Spring Guide |
| 32 | Tilt Spring |
| 33 | Pivot Pins |
| 34 | Steering Column Support Assembly |
| 35 | Wire Harness Strap |
| 36 | Steering Column Jacket Assembly |
| 37 | Adapter and Bearing Assembly |
| 38 | Steering Wheel Position Sensor Assembly |
| 39 | Sensor Retainer |
| 40 | Steering Shaft Seal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.