Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hood to the vehicle with an assistant.
  2. Align the hood hinges to the alignment marks on the hood.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the bolts to the upper hood hinge, with an assistant.

    Tighten 

    Tighten the upper hood hinge bolts to 27 N.m (20 lb ft).

    Fig 1: Installing Upper Hood Hinges
    G01616869Courtesy of GENERAL MOTORS CORP.
  4. Install the assist rods to the hood. Refer to Assist Rod Replacement - Hood .
  5. Adjust the hood. Refer to Hood Adjustment .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.