Installation Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper end of the assist rods on to the ball joint on the hood.
    Fig 1: Installing Upper End Of Assist Rod
    G01616900Courtesy of GENERAL MOTORS CORP.
  2. Install the lower end of the assist rods on to the ball joint on the lower hood hinge
  3. Remove the support from the hood.
  4. Close the hood.
    Fig 2: Installing Lower End Of Assist Rod
    G01616901Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.