Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 663 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSROOF SIDE RAIL LAMP REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Using a small flat bladed tool, open the assist handle covers.
Remove the screws from the assist handle.

Fig 1: Removing Screws From Assist Handle
Courtesy of GENERAL MOTORS CORP.
Remove the assist handle.

Fig 2: Removing Assist Handle
Courtesy of GENERAL MOTORS CORP.

Important: The plastic retainers to the side rail lamp base plate might drop out. Note the location of the retainers.
Remove the side rail lamp base plate.
If necessary, pull the service loop loose from the glue.
Disconnect the electrical connector from the side rail lamp.

Fig 3: Removing Side Rail Lamp Base Plate
Courtesy of GENERAL MOTORS CORP.
Slide the lamp socket from the base plate.

Fig 4: Sliding Lamp Socket From Base Plate
Courtesy of GENERAL MOTORS CORP.
Remove the bulb if necessary.

Fig 5: Removing Bulb From Sliding Lamp Socket
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.