Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2001CHEVY EXPRESS G2500, VAN PASSENGER EXTENDED, 5.0 MREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 598 (FRONT SUSPENSION SYSTEM)REPAIR INSTRUCTIONSSTEERING KNUCKLE REPLACEMENTREMOVAL PROCEDURE

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 M

Removal Procedure

2001 Chevrolet Chevy Express G2500, Van Passenger Extended, 5.0 MSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
Remove the brake caliper and rotor. Refer to FRONT BRAKE ROTOR and FRONT BRAKE CALIPER .

Fig 1: Removing Stabilizer Shaft Link From Lower Control Arm
Courtesy of GENERAL MOTORS CORP.
Remove the stabilizer shaft link from the lower control arm.

Fig 2: Removing Stabilizer Shaft Link From Lower Control Arm
Courtesy of GENERAL MOTORS CORP.
Disconnect the wheel speed sensor electrical connector.

Fig 3: Disconnecting Wheel Speed Sensor Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Support the lower control arm using a jackstand.
Separate the steering linkage outer tie rod ball stud from the steering knuckle using J 42188 . Refer to TIE ROD END REPLACEMENT - OUTER in Power Steering Systems.
Separate and remove the upper control arm ball joint stud from the steering knuckle using J 42188 . Refer to UPPER CONTROL ARM REPLACEMENT .
Using J 42188 separate and remove the lower ball joint stud from the steering knuckle. Refer to LOWER CONTROL ARM REPLACEMENT .
Remove the steering knuckle from the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.